Fire alarm triggered by renovation dust at Milford laundry, Milford NH
Fire & ArsonFire alarm activated at Silk Prize Laundry near Elm Street in Milford due to dust from renovation work. Fire crews responded to investigate but found no apparent fire or smoke. The alarm was likely caused by dust near the dryer machines during the business closure for remodeling.
Audio|Source: Milford Police, Fire and EMS
02:54
Transcript:
00:00
The tone is for the Milford Fire Department to respond in town near Elm Street, Silk Prize laundry.
00:07
For fire alarm activation, an indication of front zone near dryer machines. Again, the tone is for the Milford Fire Department to respond in town.
00:17
Near Elm Street, Silk Prize.
00:21
For a general fire alarm activation, an indication of front zone near dryers.
00:27
Elm Street runs from Union Square west to the Wilfrantown line and across streets of West Street from Riverway East. Time out for the Milford Company's 1510.
00:43
Sam 2 has the call 1510.
00:56
One, go ahead.
01:00
Responding.
01:03
Ah,
01:05
for a bit.
01:10
15, 10. 15, 10.
01:18
TAM2, you are correcting notifications for recall, that correct?
01:23
Yeah,
01:24
that's fire, but I know the business is closed for renovations for a bit, so I don't think we're going to be able to get in.
01:30
All right, we see.
01:37
Next day, I'm out.
01:39
Nelson's showing.
01:42
Okay, 10-5[1]-10-0.
01:49
BES unseen, nothing apparent from the exterior at this time.
01:56
Thank you.
02:04
We're making attempts for recall notification for you.
02:12
They're doing the renovations and looks like some dust may have caused the alarm to call off.
02:21
Okay, message received.
02:23
You should have the rescue pulling up momentarily.
02:30
Okay, rescue one. Go ahead.
02:34
On scene, single-level strip mall, nothing apparent from the alpha and bravo side.
02:39
Rescue one is going to be investigating with command on the alpha side.
02:45
Rescue one, you're on the scene of a single-story strip mall. You have nothing apparent from side A and B.
02:51
You're going to have command set up on the A side.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
10-5: Transmit or relay a message or information to another unit or person.
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Milford, NH
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
