Driver tried to leave scene after traffic incident on Kenwood Dr, Randolph County NC
TrafficA driver involved in a traffic incident on Kenwood Drive tried to leave the scene. Law enforcement and emergency services were requested. Air medical care was canceled after EMS arrived.
Audio|Source: Randolph County Sheriff, Fire and EMS
02:14
Transcript:
00:00
The tank 20 to runoff. Go ahead. Affirm you have anything that's being route to Kenwood Drive. Also, if you could start Signal 11[2], also. Tell me. Paying 20 to round off, you can cancel air care. It's already M.S. Copy 1022[3] area.
00:27
Mr. Reward, Meyer, Randolph Baker 16. The fire department is requested your office to respond to the 10509 can withdraws. We do have...
00:55
Maker 12. 22, alarm company of a south alarm. 104. 832. Station 20 just canceled aircare authority of 841 on Fire 1. 104.
01:22
Go ahead for tags, one. Signal 11[2] is requesting to know the reference. The driver of the car was trying to leave. Ten for him. Requesting signal level in reference to the driver of the vehicle attempted to leave the scene.
01:52
24. 13, 1023[1] on Kenwood.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
1023: Arrived at scene
[2]
Signal 11: Request for law enforcement presence or investigation (often used for suspicious situations or to secure a scene)
[3]
1022: Cancel
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Randolph County, NC
Correct
Incorrect
