Residential fire alarm triggered by malfunction, Strongsville OH
Fire & ArsonFire units responded to a residential fire alarm at near Osage Dr in Strongsville, OH, but found no fire. The alarm was malfunctioning and the homeowner planned to disconnect it.
Audio|Source: Southwest Emergency Dispatch Center (SWEDC)
00:47
Transcript:
Also, Car 4, Latter 1, respond to a residential fire alarm,8041 Osage Drive, showing hallway smoke detector will attempt to contact the premise.He'll be on fire ground 6.Car 4, Calvi.Ladder 1 is it, Rob?1458.Car 4 and Rob.1415.I don't have a car 4.Go ahead.I spoke with the homeowner.They said everything's okay.They're just having an issue with the alarm and they're going to disconnect it.No need for response[1].
Also, Car 4, Latter 1, respond to a residential fire alarm,8041 Osage Drive, showing hallway smoke detector will attempt to contact the premise.He'll be on fire ground 6.Car 4, Calvi.Ladder 1 is it, Rob?1458.Car 4 and Rob.1415.I don't have a car 4.Go ahead.I spoke with the homeowner.They said everything's okay.They're just having an issue with the alarm and they're going to disconnect it.No need for response[1].
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
No need for response: Cancel response
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near Osage Dr, Strongsville, OH 44149
Correct
Incorrect
